The project illustrates the control of up to 8 LEDs with this USB LED fader to produce individual brightness waveforms.
The device is…
Any peripheral component can be controlled by the 25-pin parallel port by assigning a high & low or ON & OFF state to each pin.
During the…
The project utilizes an Arduino in a beer fridge controller in order to control a compressor, log the temperature, and monitor the…
The circuit was designed to illustrate the operation of an electronic keypad to be utilized in the burglar alarm system by having five…
The project illustrates the addition of USB control circuit to the Hamtronics R139 WX Satellite receiver in order to have an interface to…
The Kohtauskone project illustrates the use of DMX protocol to control the strobe light which is built on top of a Pro Mini Arduino with…
The circuit allows the control of D70 remotely to release the shutter or do a bulb exposure while avoiding camera shake and could also be…
The circuit was constructed with the use of power audio amplifier LM380 in conjunction with the circuit that makes use of electronic soft…
The device was based on the HC908 daughtercard to create this simple VFO where the operation was further simplified for proving control…
A computer is used to control the ON/OFF switch of two power sockets with PIC18F4550 through the USB port.
The USB was chosen to work with…
The project uses a Nintendo GameBoy Advance with SuperCard to function as the console in building a universal remote control with…
This project mixes the commands sent from the Arduino to the transmitter with the manual input by connecting an Arduino to a Radio Control…
This portable rocket ignition system known as Launch Control is operated by a microcontroller and powered by the built-in battery.
In the…
The project is intended for typical rechargeable batteries used by R/C devices, various consumer product batteries, and electronics…
You can connect your phone to any recorder device which has a mic and remote control input. This circuit automates the recording process…
The project was designed for standalone computers to monitor and control the temperature and fan which can be run manually or…
With these mods, this circuit will last quite a long time, especially if you make things easier for the relay by turning off power to the…
The simple circuit was designed using a 555 timer and pulse width modulation for controlling the speed of DC motor.
The pulse width…
The USB controlled signal generator project was created to produce sine waves and other waveforms at audio frequencies using DDS.
In the…
The project uses wireless serial links in order to control multiple BlinkM LED modules through a modified old relay tester.
The design of…