The generator circuit was designed to produce alternating square pulses with vibrations in different parts of the circuit.
This wire mesh generator aims to create a hardware transformation unit and a high end 3D font rasterization system on the Cyclone II…
The project has been built from a modified AVR development board where the Pass key is a sweet little 5V candy bar style computer which can…
The Xprotolab is a small “all in one” device, it measures…
The project was designed to build a frequency generator based on 555 timer that can be used as a body zapper.
During the assembly of the…
The project is a second version of the AVR signal generator where it uses a single sided PCB for simplification while containing both…
The circuit was designed using the Exar 2206 IC to create the Function Generator that will produce Sine, Triangle, and Square waves with…
The idea of tesla coils are illustrated in this project which can produce big, fat, noisy sparks at least 2 inches long and be built…
The purpose of the project is to measure resistance values and generate R/C style pulses suitable for driving servos or testing R/C…
An Atmel AT90S2313 microcontroller is used to build this RS232 frequency meter which can communicate at 9600 baud through an RS232 terminal…
The USB controlled signal generator project was created to produce sine waves and other waveforms at audio frequencies using DDS.
In the…
This low-cost project aims to develop an open-source AVR USBtinyISP programmer with SPI interface that is built around the ATtiny2313 AVR…
A Microchip PIC16F628 is used as the controller chip for this low cost and simple Since/Square wave generator based on the Analog Devices…
The circuit was designed to create a frequency generator that consists of 7 steps during the operation.
This simple circuit has…
The design of the circuit is aimed to produce a device that would remove microscopic particles from the air instead of using fans and…