Member Blog Posts: open-source

  • Open Source Dot Matrix Clock

    Open Source Dot Matrix Clock

    Posted Feb 09, 2012 By Circuit Projects

    The project intends to create an open source portion on a dot matrix clock software.

    The device provides a total of 1280 LEDs from a 40×16…

    Comments(0)
  • Open Source GNU Known as Illuminato

    Open Source GNU Known as Illuminato

    Posted Feb 08, 2012 By Circuit Projects

    An ATmega645 microcontroller is used to create the Illuminato project which is a 100% open source hardware GNU.

    The use of ATmega45 is…

    Comments(0)
  • Open Source/Hardware I2C-Tiny-USB Device

    Open Source/Hardware I2C-Tiny-USB Device

    Posted Feb 08, 2012 By Circuit Projects

    The objective of the I2C-Tiny-USB project is to provide a cheap and generic I2C interface to be attached to the USB.

    The hardware of the…

    Comments(0)
  • MythTV Box Built as Open Source

    MythTV Box Built as Open Source

    Posted Feb 08, 2012 By Circuit Projects

    The MythTV has the ability to rip DVD movies to its hard drive and play them on demand although it was intended primarily to be a PVR.

    An…

    Comments(0)
  • GPS Tracker with Open Source

    GPS Tracker with Open Source

    Posted Feb 07, 2012 By Circuit Projects

    The project is a small Open GPS Tracker device that is used with cheap prepaid mobile phone to produce a GPS tracker.

    During the…

    Comments(0)
  • Low Cost Auto Pilot Known as ArduPilot

    Low Cost Auto Pilot Known as ArduPilot

    Posted Feb 06, 2012 By Circuit Projects

    The ArduPilot is based on the open-source Arduino platform which will be used as navigation-only autopilot.

    The design of ArduPilot refers…

    Comments(0)
  • Micro-RC Repeater Controller with Open-Source Feature

    Micro-RC Repeater Controller with Open-Source Feature

    Posted Feb 02, 2012 By Circuit Projects

    The Micro-RC repeater Controller device was modernly designed based on GNU open-source while all SMD components are utilized.

    An Atmel…

    Comments(0)
  • Swarm Robot Project with Open Source Design

    Swarm Robot Project with Open Source Design

    Posted Feb 02, 2012 By Circuit Projects

    The project aims to produce open source swarm robots that are fully autonomous with programmable and natural emergent behavior in a…

    Comments(0)
  • USB-Interfaced Atmel AVR Programmer

    USB-Interfaced Atmel AVR Programmer

    Posted Jan 27, 2012 By Circuit Projects

    The project utilizes an open source Atmel AVR microcontroller while incorporating a state of the art USB programmer.

    The firmware of the…

    Comments(0)
  • Servo Robot Using Arduino for Control Features

    Servo Robot Using Arduino for Control Features

    Posted Jan 24, 2012 By Circuit Projects

    This open source project aims to create a fully programmable SERB package which can be used for any robotics projects.

    The SERB package…

    Comments(0)
  • SparkFun: Why Open Source?

    SparkFun: Why Open Source?

    Posted Jan 10, 2012 By Peter Dokter

    Over the past few years, SparkFun has had some amazing success. And that’s due in no small amount to the idea of open source. How so? Through…

    Comments(0)
  • Arduino for mere m0rtals - Part 2

    Arduino for mere m0rtals - Part 2

    Posted Nov 29, 2011 By Robert Berger
    Disclaimer

    The views, opinions, positions or strategies expressed by the author and those providing comments are theirs alone, and do not…

    Comments(1)
  • Arduino for mere m0rtals - Part 1

    Arduino for mere m0rtals - Part 1

    Posted Nov 13, 2011 By Robert Berger
    Disclaimer

    The views, opinions, positions or strategies expressed by the author and those providing comments are theirs alone, and do not…

    Comments(3)
  • A System Perspective on Specifying Electronic Power Supplies: Source Characterization

    A System Perspective on Specifying Electronic Power Supplies: Source Characterization

    Posted Oct 30, 2011 By Bob Stowe

    Last month we discussed the effects of load characteristics upon power supply specification. This month we will learn about important source…

    Comments(0)
  • RepRap: A self-replicating desktop 3D printer, open source.

    RepRap: A self-replicating desktop 3D printer, open source.

    Posted Dec 08, 2010 By Bob Casiano

    Desktop 3D printer for your home!

    I want to add this to my collection of garage implements. The RepRap is a desktop 3D printer capable of self…

    Comments(0)
 
Click Here