The USB in-circuit programmer for Atmel AVR controllers is termed as USBasp which consists of an ATmega48 or ATmega8 along with a couple of…
The project allows an easy transfer of hex programs to most Atmel AVR microcontrollers without the need for high cost and constraint…
The project was a modification of a JDM PIC programmer and has to be connected through the serial communication port of the computer…
The circuit was based on the use of Arduino AVR to build a high voltage programmer which can be used to fix pesky fuses.
There are cases…
The project uses a USB hub with 4 ports that can be enabled and disabled from PC software in order to create pulses on each hub output for…
The project allows the programming of a PIC in circuit while avoiding the need to constantly take in and out of the programmer with the…
The project will function as a wireless programming and debugging link to access hard to reach Arduino board inside a machine by using the…
The reprogramming of the Lily main board was easily allowed by the USB to UART board that does not require the need for soldering.
The…
The project utilizes an open source Atmel AVR microcontroller while incorporating a state of the art USB programmer.
The firmware of the…
The project illustrates the use of AVR ISP to develop software in an AVR Studio 4 environment to directly program chips.
There are some…
The HVProg project is a high voltage parallel programmer with the utilization of AVR microcontrollers for the purpose of disabling the…
The design of the project utilizes the parallel programming mode through parallel port in order to create this 2052/4052 programmer.
For…
The circuit of AVR In-System-Programmer (ISP) has been modified to function with USB connection to a PC.
The modification of the old AVR…
The project was named as JDM Programmer used for burning small PIC’s and as a serial programmer, it works on the serial port RS232 of a…
The project includes clock & data filter and voltage divider for modern PIC microcontroller using an updated JDM2 PIC programmer.
The…
This small controller board allows you to program ATTiny2313, AT90S1200 and AT90S2313 microcontrollers via RS232 port and provides…
The project was built as a serial PIC16F84 programmer that does not require an external power supply since it extracts power form the RS232…
This programmer communicates to a host using RS232 serial port in order to program devices from the PIC16F87X family.
The settings of the serial port include 9600 bps, 8 data bits, no parity, and 1…