The project creates a RFID tag emulator that can be connected to a computer through the RS232 port for emulation.
A standard 125kHz EM4001…
The project uses an Atmel ATtiny85 AVR microcontroller and a coil to build an RFID tag.
The AVR is being powered by the coil through two…
A quick electromagnetic burst is used by this gun that flows through the tag and in return, the RFID chip is fried.
The coil is featured…
The design of the project integrates an RFID development board with a PIC16F877A on a low cost CDbot robot.
The completion of the set in…
The project aims to create a phone system based on RFID which allows the user to dial the desired numbers based on a picture placed near or…
The project creates a prototype active RFID tracking system which makes use of mesh networking wherein only a single reader needs to be…
The project utilizes an intelligent RFID cat tracker in order to create the CATaLOG device which has the ability to track the cat as it…
The RFID door unlocker is based on a PIC16F630 microcontroller in which the purpose is to unlock any college dorm doors by allowing a…
The project uses an ID-12 RFID chip and a PIC12F629 microcontroller to create a car immobilizer which can cut the ignition with relay and…
The purpose of the project is to spoof a simple low frequency 125kHz RFID tag with the use of an Arduino and only a few components.
A…
The project utilizes a PIC16F628A with an on-chip comparator in order to feed the output from the op-amp directly into the PIC and extract…
The circuit was built to read and decode the RFID tags with 125 KHz frequency using a single low cost ATtiny2313 ATMEL…