The project was based on 3 LEDs to form the Red, Green, & Blue in place of a real RGD LED on a PCB that is connected to the controller…
The face of the desk clock utilizes RGB LEDs wherein a color is assigned to each hand and the colors are mixed as the hands overlap on the…
This project is a better version compared to other RGB LED controller since it is intelligent enough to understand different color palettes…
The project shows the high power LED mood light design based on PIC16F628 microcontroller with the ability to produce PWM pulses wherein…
A combination of a PIC and three constant current buck converters is the design of this circuit to create the RGB LED controller that…
The project produces a large spectrum of colored light which is a mixture of bulbs in red, green, and blue color while being operated using…
The project shows the ability to control the color of LEDs at each corner of the board independently.
Along with the independent control…
The project utilizes a “remote control(remote…
The Shift Brite project utilizes a simple clocked serial interface to receive a 10bit brightness value for each color to produce over a…
The RGB LEDs contain full color pixels arranged in 16 wide by 24 tall arrays which can be used to display informational graphics, audio…
This project enables the writing of custom games which can be controlled through the Arduino development environment as it is fully driven…
In this project, the RGB LED contains 3 LEDs encased in one shell which looks like a single white LED except that it has for leads where…
A small Atmel AVR ATtiny13 microcontroller is utilized by the project where it is pre-programmed with several different display modes that…
This full color RGB mixing lamp is intended to control the room light according to the mood of the user.
The project is a standalone…
The project allows the controller to manage the color of RGB LEDS by setting the desired color on the LED.
The board will let a color or…
This low-cost project aims to develop an open-source AVR USBtinyISP programmer with SPI interface that is built around the ATtiny2313 AVR…
The project illustrates the use of VGA to SCART interface for converting RGB which allows a VGA card to TV using a few common…
The implementation of a RGB LED fader using 555 timer and 4029 digital IC is the objective of this project.
During the operation, the RGB…
A logic level N-channel high power MOSFET is used to create this RGB LED driver that would allow LED arrays or lamps of up to 5A per…
This small and simple circuit allows you to connect your VGA card to your TV via SCART with the great advantages of using RGB over…