extreme_circuits

Extreme Circuits

Circuit Design Blogger

Extreme's Blog :

Return to Blog

Battery Charger Regulator

Most off-the-shelf car battery chargers cannot not be left connected to the battery for long periods of time as over-charging and consequent battery damage will occur. This add-on circuit is placed in series with the battery being charged and is powered by the battery itself. In effect, the circuit uses a high-current Mosfet to control the charging current and it turns off when the battery voltage reaches a preset threshold. Power for the circuit is fed from the battery to 3-terminal regulator REG1 which provides 8V.

LED1 indicates that the battery is connected and that power is available. The 555 timer IC is configured as an astable oscillator running at approximately 100kHz. It feeds a diode pump (D1 & D2) to generate adequate gate voltage for Mosfet Q3, enabling it to turn on with very little on resistance (typically 14 milliohms). With the Mosfet turned on, current flows from the charger’s positive terminal so that charging can proceed. The battery voltage is monitored by 10kO pot VR1.

Battery Charger Regulator Circuit Diagram

Battery Charger Regulator Circuit Diagram

When the wiper voltage exceeds the conduction voltage of zener diode ZD1, transistor Q1 turns on and pulls pin 4 (reset) low to switch off the 555 and remove gate drive to the Mosfet. This process is progressive so that the cycle rapidly repeats itself as the battery charges. Eventually, a point is reached when the battery approaches its charged condition and the cycle slows right down. Transistor Q2 and LED2 function as a cycle indicator. When the battery is under charge, LED2 appears to be constantly on. When the battery is fully charged, LED2 briefly flicks off (charging) and returns to the on state (not charging) for a longer period.

Author: Paul Walsh

Tags: 555, battery charger, 7808, regulator

Comments on this post:

Thanasis Katsambas

9 months ago:  Mr.Paul Walsh,

I have constructed your design and works perfectly OK.
Very good design. Well done.
I have tried to modify your design to work for 24V batteries but unfortunately without success.
Could you please Help me?

Thanks in advance

Tsitsios

Login or Register to post comments.
x
Like free stuff?
EEWeb Weekly Giveaway Sponsored by Mouser This Week: TI Low Profile NEXFet power supply dev kit!
Enter Here
Login and enter if you're already a member.
Click Here