Processing...

Electronics and Electrical Engineering Design Forum

 

Analog

ad 620 amplifier shibas

Iam posting my circuit diagram of the Ad 620 instrumentation amplifier and the values of components used in the circuit in two separate attachments.please refer to it and mention any change if i have to make to the circuit to get the amplified output.When i connected this circuit first i was not getting the required gain.But now iam getting very huge gain than the gain that is required.The gain equation for ad 620 is G=(49.4k/rg)+1. isn’t it? I need a gain of about 100 or below 100.please help me.I used the 0.1 uf capacitor between the input signal and the non inverting input to remove the dc offset components.Is that correct to use it?

Do i need to insert a resistor between the inverting and non inverting input terminals of the op amp and ground that resistor to reduce the effect of the input bias current?
Some body please help me.

If the circuit diagram is wrong somebody please reply or upload a correct circuit diagram of the instrumentation amplifier using ad 620 ic.

Attached Files:
lordshibas@gmail.com
Asked By:
Shibas
1 year ago
 
 
{username}
Score: 0

you would need some dc bias resistor for input of the amp, refer to the datasheet, or see the attached. almost all amp i know of need this to work.

the gain calc should be piece of cake, so i assume that you did it right :)

Attached Files:
» Reply
 
{username}
Score: 0

Check that the gain setting resistor Rg is properly connected.
Check it’s resistance.
Try different resistors for Rg and see what happens.

» Reply
Login or Register to discuss this topic.
x
Like free stuff? Enter Here!
EEWeb Weekly Giveaway Sponsored by Mouser This Week: FTDI Chip - FT800 Adapter Black 3.5 Display & Bezel
Enter Here
Login and enter if you're already a member.
Click Here