EEWeb Member Projects: pcb-design
-
Line Following Sensor
Posted May 23, 2012 By Nikhil DhandareIn robotics when we make line follower either black line follower or White line follower we need line follower sensor. Easy method to make…Comments(0) -
Comments(3) -
USB to RS232 convertor Part 1
Posted Feb 24, 2012 By Mark HarringtonIf you are stuck for a USB to serial conversion this is the answer to a complete solution using the FTDI Chip available from FTDI.com and provides…Comments(0) -
2-Dimensional Arithmetic Fourier Transform Image Sensor
Posted Jun 03, 2011 By Edwin TanThis is a design and fabrication of a CMOS image sensor with a non-uniform layout of pixels that enables the arithmetic Fourier Transform (AFT)…Comments(2) -
5V TTL/3.3V Bidirectional Level Shifter
Posted May 28, 2011 By Edwin TanA separate project required to convert data signals from one voltage level to another. A module needed to be built as a ‘middleman’ between these…Comments(0) -
Design a Multi-Chip Module
Posted May 11, 2011 By Akila SrinivasanDesign a Four Chip Module which consists of a DSP chip, a RFIC and two memory chips (MEM A and MEM B). The RFIC supports a Global Positioning System(GPS) in the bandwidth of (1575 MHz ± 100 MHz) and…Comments(0) -
VLSI BASED PID CONTROLLER (UNDERGRAD GRADUATION PROJECT)
Posted Mar 27, 2011 By Rahul GabaDeveloped VLSI front end code to interface ACTEL FPGA with 230V heating system. Learned the functioning and calibration of a PID controller.Comments(0) -
Cortex-M3 MCU STM32-based LCD controller
Posted Mar 21, 2011 By Tian ChuThis is an embedded system application project finished during my intern at ST Microelectronics (Shanghai) Co.,Ltd. This project provided me a…Comments(0) -
Project based on Temperature Data Logger
Posted Mar 11, 2011 By ATIT PATELWorked on Project based on Temperature Data Logger which sense and records the Temperature in computer every consecutive period of time at Sahajanand…Comments(0) -
Boot Alarm II
Posted Feb 25, 2011 By Joshua BishopNow I’m at the breadboarding stage of the project, testing out code and verifying that all of my ideas work. I’ve also settled on certain design ideas that were up in the air for awhile. The boot…Comments(0) -
Boot Alarm I
Posted Feb 05, 2011 By Joshua BishopI’ve been working on a project recently. It was envisioned over a year ago, and then set aside and picked up and then set aside and then picked up again without any real progress for nearly a year….Comments(0) -
Underwater Acoustic Pinger Locator
Posted Feb 02, 2011 By Matt JohnsonIn the field of autonomous underwater robotics, it is often desirable, and indeed necessary, to “ground truth” the position of the robot to a known…Comments(1)
