Advertisement

Electronics and Electrical Engineering Application Notes

Read the latest electronics engineering product design Application Notes.

Category: Analog Design

All Application Notes

Auto Gain Contol

This application note explains about an Auto Gain Control (AGC) for FM Radio Frequency using ON Semiconductor's NSVP264SDSF3, NSVR351SDSA3 and NCV2904. NSVP264SDSF3 is a dual type PIN diode best ...

DPA-Switch™ DC-DC Forward Converter Design Guide

The single-ended forward converter topology is usually the best solution for DC-DC applications in industrial controls, Telecom central office equipment, digital feature phones, and systems that use distributed power architectures.  ...

350 mA Buck Boost LED Driver using BJTs, HSCS and a NCP3063 Controller

Unlike traditional lighting, LEDs require driver solutions that address the challenges of providing a constant current to a load whose output voltage can vary by ± 30% because of process ...

Magnum Edge Switch Networks LAPD Cruisers

The Los Angeles Police Department (LAPD) is the third largest police department in the United States with over 10,000 officers responsible for a 500 mile, four million person area. With ...

Designing With The HMC346MS8G Voltage Variable Attenuator

The HMC346MS8G is an absorptive Voltage Variable Attenuator (VVA) in an 8 lead surface-mount package operating from DC - 8 GHz. It features an on-chip reference attenuator for use with ...

Class D Audio Amplifier Using PIC24FV16KM202

Class D amplifiers have become a popular audio amplifier topology due to their high efficiency and subsequent low cost. The high current output stage is implemented using binary switches, resulting ...

Optimizing your Power Amplifier for Predistortion with RF PA Linearizer

This document provides guidelines for designing a power amplifier to achieve optimum performance with Maxim's radio frequency (RF) power amplifier (PA) linearizer (RFPAL) or other types of predistortion. Using RFPAL ...

Design for a Wideband, Differential Transimpedance DAC Output

High-speed digital-to-analog converters (DACs) commonly offer a complementary current output signal. Most output interface implementations use either a resistive load and/or a transformer to convert this current source signal to ...

Ways to Optimize the Performance of a Difference Amplifier

There are times when a small signal needs to be measured in the presence of a large common-mode signal. Traditional instrumentation amplifiers (in-amps) that have two op amp or three ...

Half Bridge LLC Resonant Converter Design using ICE1HS01G

This application note describes how to design half bridge LLC resonant converter using ICE1HS01G, which is an 8-pin LLC controller developed by Infineon Technologies. ICE1HS01G is specially designed for applications ...